So as the heading says, this is for Matty's Auxiliary Switchgear units for his Hs2 Streetfighter system I am building for him.
I posted a 3D design of one, but as usual I hit my head against the wall a few times and came up with a slimmer and nicer design.
In the pic below the top one is the old design test plate, bigger and far longer to print, plus it would not look good from behind as it had no back.
The lower, slimmer one uses the buttons as part of the body to make it smaller and also give a better appearance from behind. The button caps just sit nice and snug on the buttons to provide a clean look. All wiring will be hidden too.
The next pics show the unit with and without the covers.
The button units can be mounted in any position on the bars and hve cutouts in the bridges for cables to pass through to keep it all tidy.
Printing the other unit now and will post pics of the different placements on the bars.
Bit behind on Matty's system as I did a re-design of some things again.....
DD
I posted a 3D design of one, but as usual I hit my head against the wall a few times and came up with a slimmer and nicer design.
In the pic below the top one is the old design test plate, bigger and far longer to print, plus it would not look good from behind as it had no back.
The lower, slimmer one uses the buttons as part of the body to make it smaller and also give a better appearance from behind. The button caps just sit nice and snug on the buttons to provide a clean look. All wiring will be hidden too.
The next pics show the unit with and without the covers.
The button units can be mounted in any position on the bars and hve cutouts in the bridges for cables to pass through to keep it all tidy.
Printing the other unit now and will post pics of the different placements on the bars.
Bit behind on Matty's system as I did a re-design of some things again.....
DD