Author Topic: m1 silverstone setup  (Read 801 times)

vini97

  • Hero Member
  • *****
  • Posts: 1484
  • und dann vollgas
    • View Profile
m1 silverstone setup
« on: May 27, 2016, 04:06:19 AM »
hi


after a lot of testing and tweaking, here is my m1 setup for silverstone.
very high tail for maximum turn-in/apex speed, rear tyre likes to slide :D
getting the gearing right took a lot of time and it's specifically set up for riding without TC and AW.
if you don't slide the rear tyre as much, you might want to put a little bit more pressure in to get it to 2.45bar, or even go to the soft tyre if it lasts long enough.


hope it works for you
« Last Edit: May 27, 2016, 06:57:53 AM by vin97 »
es gibt nur ein gas

CapeDoctor

  • Hero Member
  • *****
  • Posts: 872
  • ...taking fun seriously since 1968...
    • View Profile
Re: m1 silverstone setup
« Reply #1 on: May 27, 2016, 05:47:25 AM »
i'll give it a go, cheers vin :D

vini97

  • Hero Member
  • *****
  • Posts: 1484
  • und dann vollgas
    • View Profile
Re: m1 silverstone setup
« Reply #2 on: May 27, 2016, 06:09:31 AM »
just so you know, i'll probably end up using 2.10/2.10bar for the race (instead of 2.15/2.15) to avoid overheating after 10+ laps.
i hope the soft front tyre will last the whole race.
i cannot use the assymetric or hard front because they will overheat for me (with a full tank) after only a few laps.
es gibt nur ein gas