PiBoSo Official Forum

General => Off Topic => Topic started by: BOBR6 84 on May 19, 2015, 09:34:42 PM

Title: Anybody know for sure?
Post by: BOBR6 84 on May 19, 2015, 09:34:42 PM
Will an R1 slipper clutch fit on a 2001 R6?

Before I give it a try..
Title: Re: Anybody know for sure?
Post by: C21 on May 20, 2015, 07:44:35 AM
NO.  ;D
Completly different clutch basket....
Title: Re: Anybody know for sure?
Post by: BOBR6 84 on May 20, 2015, 09:10:53 PM
Haha ok thanks  :D That's a shame.. Hoping to save some pennies their  :-\
Title: Re: Anybody know for sure?
Post by: C21 on May 21, 2015, 07:12:08 AM
you even can´t use the slipper of the R6 2006-
i know someone that modified the clutch to use this one in a 2003 r6 but you need machines and special tools.
if you wan´t a good and cheap slipper you can buy the TSS or Yoyodyne unit. Works good and is not as expensive as the Suter, Sigma or any other manufacturer.

saving pennies i something that is totally unknown in racing  ;)
Normally wasting millions of pennies is normally.... ;D
Title: Re: Anybody know for sure?
Post by: BOBR6 84 on May 21, 2015, 09:16:52 PM
Thanks il check those out.. ;)

I looked at the sigma slipper its around £500.. I wanted this R1 clutch to fit it was free  ;D >:(

I try to spend as little as possible with racing.. But, it never works lol  ::) anyway a slipper will be a worthy upgrade so why not  ;)

Thanks for the info!
Title: Re: Anybody know for sure?
Post by: EdouardB on May 27, 2015, 08:32:00 AM
Bob, even if it did fit, unless you can fine tune it, it would be a bit useless as it is set up for the R1's engine inertia and not the R6.
Title: Re: Anybody know for sure?
Post by: BOBR6 84 on May 27, 2015, 09:41:34 AM
Ok no worries the idea is scrapped  ;) the guy who tuned my bike could probably do something with it but it sounds as though its not worth the hassle.. I have no idea so thanks for the info!