PiBoSo Official Forum

Hi,
I would like to know if it is possible in the moto file to change the throttle curve?

Thanks you

I've found some information here
http://forum.piboso.com/index.php?topic=787.msg8392#msg8392
but don't understand what it means
The throttle goes from 0 to 1.0
Question

Quoterpm0 = 8000
         rpm1 = 10000
         rpm2 = 15000
         rpm3 = 17000
         throttle = 0.85

and the answer is

Quoterpm0 and below = 1.0
rpm0 to rpm1 = interpolation
rpm1 to rpm2 = throttle
rpm2 to rpm3 = interpolation
rpm3 and above = 1.0

I would like to make the moto more sensitive in curve , to adjust the moto position with the gaz , and actually there is too much delay to make it really reactive.

Thanks

What bike are you trying to modify? And why exactly?

Are you trying to make it acceerate faster?

I would like to change the murasama 900.
Yes I want to make the throttle more reactive

I'm note sure I understand what you're trying to achieve (and I suspect the throttle curve is not the solution) but if you put "throttle = 1.00" instead of "throttle = 0.85", then your throttle map is "neutral" (like in no throttle map at all).

But your controller input it the throttle? (assuming you are using a controller)

Unless there is something I'm not aware of, the throttle sensitivity can't be changed.

Bikes can have a throttle map: it's a property of each bike, not something a user can set.