Hi I have attempted to make a sort of controller and I am after some advice on what type of front brake and pressure transducer to use , also was wondering if the transducer thread is the same as the master cylinder? Any advice much appreciated
You would need to have a slave cylinder in the system, or the brakes will feel too stiff.
Order a transducer with the right threads, and it will fit. Something like this;
Transducer 1000psi (https://www.ebay.com/itm/Pressure-transducer-or-sender-15-100-200-300-1000-psi-5V-for-oil-fuel-air-water/312004049546?ssPageName=STRK%3AMEBIDX%3AIT&var=610773941125&_trksid=p2057872.m2749.l2649)
Then a three way tap where you put the transducer;
Three way split (https://www.summitracing.com/parts/fra-599903)
Quote from: pikey on March 03, 2021, 09:50:05 PMHi I have attempted to make a sort of controller
And also, most importantly,
Pics, or it didn't happen! ;)
Thanks Chris I will try and get some bits ordered at the weekend
Quote from: pikey on March 04, 2021, 07:52:26 AMThanks Chris I will try and get some pictures taken at the weekend
Excellent! :D