Quote from: poupou59890 on July 10, 2019, 06:11:53 AMHi Folks,
Just to let you know, I install everything on my chassis, put the t300rs, polys, and foot lever at the right place, everything is fine, the only issue I have is that the plastic part I use to connect t300rs and my handlebar is not strong enough, when i am on the bike and try to lean the plastic part start to crack... so I found the solution I will use a steel pivot and then I will connect it to the t300rs so the wheelbase never see any weight or strengh. I will do that this week I hope, then I need to finally finish my gear change lever and everything will be set up for the first start.
It looks quite good for now I will make a full post about my project when it will be done, so you will have all info or feedback I had..
Just need to weld everything correctly now that everything is in place.
I will keep you updated
Have a nice day everyone.
Sounds very nice