Messages

You're doing something wrong guys, m_fSteer is the steering angle ...

You're the expert, and I'm glad you chimed in, but how are our observations wrong? That variable seems to respond exactly as the rear slide would. It doesn't matter what it's supposed to represent. The variable stays at 0 degrees most of time and only fluctuates approximately 4 degrees(usually  less then 4) in turns depending on braking and acceleration. When the rear loses traction, that variable seems to go to a maximum angle of 25 degrees in either direction before the bike crashes. Why does this need to be more complicated?

I've been testing for traction loss as well. m_fSteer seems to work well as rear traction. I think thats what the variable is called. pos = 153 in the processing sketch.

@Chris_Beeves what is the leonardo's resolution for analog axes? I think it's 8-bit (255 steps), but I'm not sure. The leo bodnar board is 12-bit (4096 steps), so it might be the better choice. Although it is much more expensive.

That sounds nice, but milestone has lost my trust completely. They won't get another penny out of me.

USB3 might be an issue. I had some problems with the fanatec pedals when they were connected to a usb2 on the motherboard. I would get usb malfunctioned message and the pedals were no longer detected. After trying every usb on my pc, including USB3, I would get the same message and disconnect. I tried a powered usb hub, and now the pedals are always detected and I never get usb malfunction messages anymore. A powered usb hub might be worth a try. It sounds like you could use a few extra usb ports anyways.

Having nearly the same issues with an AccuForce wheel and Fanatec pedals in WRS. WRS will recognize the pedals when I Calibrate the Fanatec inputs but it won't recognize the AccuForce input. When I calibrate the AccuForce it sees it just fine but doesn't see the Fanatec items. I can not get the two to work together. I think I need to connect the Fanatec pedals to the AccuForce controller via the supplied Analog Inputs so that the AccuForce controller is the only item listed under calibration.

this is strange. my accuforce and fanatec pedals are connected separately and they both are recognized.

God is dead..

Like time, God exists only as long as humans exist...

Nothing is eternal on the Universe. Except the Time...

Time is a human construct, it is not eternal...

I see they finally legalized marijuana in your state. XD

http://youtube.com/v/cTIMlGub4F4

great cover...

http://youtube.com/v/6E1DkgUNfBc

http://youtube.com/v/V1vRityLrhY&t

I still play. But much less (like gpbikes) since I'm very busy at work. Still mostly timetrials, since finding an online race is almost immpossible. I have never actually been able to find a race online, and have only tried online multiplayer by joining by invite 2 or 3 times. I've read at racedepartment that the consoles have many ppl online, but not on pc.

here you go

Hmm. I have the exact same setup. T500 with fanatec v3 pedals. No problems here.

The neighbour's aren't gonna be impressed. First the noise, and now a skunky cloud of smoke 

http://youtube.com/v/EQHNtTQLvFQ

I still can't do a clean lap but i'm getting closer

http://youtube.com/v/sozj95CnzUk