Please make sure your nickname is correctly set in GP Bikes -> Profiles -> Nickname
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Quote from: andrea.fiorelli on October 30, 2016, 01:35:39 PM
Hi PiBoSo...I found a issue on GARAGE section...when I try to compare 2 setup on tab REAR SUSPENSION it not compare the 2 setup but it show on red only the SPRING/BUMP/REBOUND of the first setup.
I hope that you understand that I want to say.
On 1st image default
On 2nd image my setup
On 3rd image the compare...look at the REAR SUSPENSION tab and pay attention at SPRING/BUMP/REBOUND
Thank, Andrea
Quote from: BozoCRO on October 30, 2016, 08:32:22 AM
There was once a realistic version of Monza, but there was no way in hell to reach realistic top speeds, so someone made the straights longer
If I remember correctly Murasama could barely reach 300 km/h on the "realistic" version.
Quote from: h106frp on October 28, 2016, 12:09:55 AMQuote from: PiBoSo on October 01, 2016, 01:33:16 PM
Now the scene must be set for every element, to allow, for example, to have analog gauges on the chassis and also a digital dash mounted on the steer.
- "cockpit/gauges/analog_scene" for the analog gauges
- "cockpit/gauges/gearup_led/scene" for the gear shift light
- "cockpit/gauges/rpm_lights/scene" for the rpm lights
- "cockpit/gauges/pit_limiter/scene" for the pit limiter light
- "cockpit/gauges/lcd/scene" for the LCD
- "cockpit/gauges/lcd2/scene" for the second LCD
- "cockpit/gauges/lcd3/scene" for the third LCD
The possible values are 0 ( chassis, the default ) and 1 ( steer ).
By trial and error it appears to be;
- "cockpit/gauges/lcd/scene" for the LCD
- "cockpit/gauges/lcd1/scene" for the second LCD not 2 as described