@Piboso
Is it possible to add a 4th stepangle/value to analog displays?
This analog display has 3 different steping angles:
From 0 to 6000 --- 6000 to 7000 --- 7000 to top rpm
It's a Dellorto Matrix4 Dashboard
Seems GPB can only accept 3 angle steps 0-1-2, doesn't work with a fourth.
This work, but is not accurate below 7000rpm
I would need this:
Thank you !
Is it possible to add a 4th stepangle/value to analog displays?
This analog display has 3 different steping angles:
From 0 to 6000 --- 6000 to 7000 --- 7000 to top rpm
It's a Dellorto Matrix4 Dashboard
Seems GPB can only accept 3 angle steps 0-1-2, doesn't work with a fourth.
This work, but is not accurate below 7000rpm
Code Select
rpm_analog
{
enable = 1
needle = rpm_needle
axis = y
step0value = 2906 (from idle....)
step0angle = 10
step1value = 7000 (to 7000....)
step1angle = 37
step2value = 14000 (to top rpm)
step2angle = 172
}
I would need this:
Code Select
rpm_analog
{
enable = 1
needle = rpm_needle
axis = y
step0value = 2906 (from idle....)
step0angle = 10
step1value = 6000 (to 6000....)
step1angle = 23
step2value = 7000 (to 7000....)
step2angle = 38
step3value = 14000 (to top rpm)
step3angle = 172
}
Thank you !